Roborock QX0PEA maintenance set

The Roborock QX0PEA is one of the market codes for the entry Qrevo platform, so it carries the same 5,500 Pa hardware: a single DuoRoller rubber main brush and the dual spinning, liftable mops, with a first-generation Multifunctional Dock that cold-washes the pads, warm-air dries them at 45°C and auto-empties into a sealed dust bag. Upkeep tracks that platform exactly – the HEPA filter loads over two to three months at this suction; the main brush lasts five to seven months but needs wrapped hair cut along the roll and both end-cap bearings cleared every one to two weeks; the spinning mop pads wear at the outer edge and should be inspected near the eight-week mark; the side brush splays against skirting across three to six months; and the dock dust bag fills in about three to five weeks.

This maintenance set keeps all of those intervals stocked with Plus.Parts® components built as a direct-fit alternative to the original Roborock part 8.02.0269: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags, every piece matched to the QX0PEA’s own mounts and dock. With four of each consumable, one order carries the robot through several full service cycles. The filters are the part that protects performance – at 5,500 Pa a tighter HEPA media holds suction steady across the interval, while a loose generic filter lets fine dust drift back into the room and makes the motor work harder than it needs to.

The mop pads keep their absorbent nap under the dual plates’ constant spin rather than wearing bald at the rim early, the sealed dust bags keep the auto-empty cycle from stalling mid-transfer, and the DuoRoller rubber stays flexible so the brush keeps even grip instead of hardening and rattling. Behind the set is a real team at VacuumReviews.eu: because the QX0PEA is one of the Qrevo’s market codes, it takes the same 8.02.0269 kit as the Qrevo, the P10 and the QR52-00, so if you are not sure which name is on your machine, or anything else comes up, reach out and we will get it sorted.

At a glance

• Matched to Your Device – Main brush, side brushes, filters, mop pads and dust bags are all sized to the QX0PEA / Qrevo platform, so each part fits without adjustment or guesswork.
• A Full Service Stock – Four side brushes, four filters, four mop pads and four dust bags supply several replacement cycles from a single order.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.